FT Simple Soarer Custom Motor Mount 16x19
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
While rebuilding my trusty old FT Simpler Soarer, I found jason51873's nice little custom motor mount and printed one…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 225
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
While rebuilding my trusty old FT Simpler Soarer, I found jason51873's nice little custom motor mount and printed one out right away. (https://www.thingiverse.com/thing:2506484)
Only then did I think about measuring the motor mounting holes and realized it didn't fit my NTM Prop Drive Series 28-26A 1200kv which has a 16mmx19mm mounting pattern. Whoops! So I designed this remix from scratch following his original design but made it fit the somewhat standard 16mmx19mm mounting pattern.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2S
No
Supports:
No
.20
Infill:
20%
Notes:
This STL will come into your slicer upside down. MAKE SURE you flip it over 185 degrees to get the motor mounting area flat on the printer bed!
Post-Printing
Make sure to orient STL this way to avoid supports.
Enlarged vent hole to more easily allow motor wires to pass.
Ready for re-maiden
How I Designed This ===================Fusion 360
Category: R/C Vehicles