RepRack Polydryer Shelf
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Shelf for Polydryer that works with the Reprack hangers.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 45
- Wydruki
- 1
- Wyświetlenia
- 1109
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This shelf is used with the standard Polyworks Polydryer, by printing two of the RepRack hangers and cleats, the shelf attaches in where the ½" EMT pipe would normally be used. They are a tight fit by design to ensure they are stable and don't come out of the reprack hangers easily.
The shelf contains two pegs that fit into the screw holes in the bottom of the Polydryer to keep it from sliding off the shelf when adding/removing containers. I also added two holes (but can be removed if needed) to the sides of the shelf to mount PC4-M10 pneumatic fittings (e.g., https://www.amazon.com/gp/product/B01KHN1HWY) to to run the PFTE tubes through.
Found that using PETG worked best for the RepRack hanger and cleat, and used PLA for the shelf itself.