1 / 2
NSPanel Pro in dual-gang box supplemental faceplate — zdjęcie 1
1 / 2

NSPanel Pro in dual-gang box supplemental faceplate

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Wstępna wycena dla PETG

0,53 € – 0,64 € netto (bez VAT)

Dla pliku: Half a wall plate_0.4n_0.15mm_PETG_MK4S_29m.bgcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,59 € netto (środek widełek).

Masa podana przez autora
10 g
Czas druku podany przez autora
29,4 min
Materiał u źródła
PET
Materiał wyceny
PETG
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Holes in the wall look bad

Ocena
0 / 5
Polubienia
3
Pobrania
20
Wydruki
0
Wyświetlenia
486
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
Creative Commons — Attribution — Share Alike

Had a 2-gang box where I wanted to mount the NSPanel Pro, requires a less-than-half faceplate to cover the rest of the hole.

Included is both a standard faceplate with screws, and a screwless one (two parts)

Screwless option requires you to attach the inside piece with flat head screws to the electrical box, use outlet spacers/standoffs if necessary to make it flush with the wall, place outside (faceplate) part over the bottom of the inside part, there is a groove that it fits into, pull upwards bending the inside piece toward you (away from the wall) slightly, then snap over the top of the inside piece.

I did this in PETG, no reason why PLA wouldn't work so long as the location isn't in direct sunlight (might warp over time)

Tagi