NSPanel Pro in dual-gang box supplemental faceplate
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Holes in the wall look bad
- Rating
- 0 / 5
- Likes
- 3
- Downloads
- 20
- Makes
- 0
- Views
- 486
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Home Decor
- License
- Creative Commons — Attribution — Share Alike
Had a 2-gang box where I wanted to mount the NSPanel Pro, requires a less-than-half faceplate to cover the rest of the hole.
Included is both a standard faceplate with screws, and a screwless one (two parts)
Screwless option requires you to attach the inside piece with flat head screws to the electrical box, use outlet spacers/standoffs if necessary to make it flush with the wall, place outside (faceplate) part over the bottom of the inside part, there is a groove that it fits into, pull upwards bending the inside piece toward you (away from the wall) slightly, then snap over the top of the inside piece.
I did this in PETG, no reason why PLA wouldn't work so long as the location isn't in direct sunlight (might warp over time)