1 / 11
Chronicles of Avel / Kroniky Avelu — zdjęcie 1
1 / 11

Chronicles of Avel / Kroniky Avelu

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Improved model by Declon with magnets, lids and separate tray for coloring book.

Ocena
5 / 5
Polubienia
17
Pobrania
106
Wydruki
1
Wyświetlenia
781
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Board Games
Licencja
Creative Commons — Attribution — Noncommercial

The parts with coloring book and corresponding lid will fit even if rotrated any part of stack by 180°. Will fit each way.

Accessorits_tray has implemented also Naitakal's remix with imcreased compartments space. https://www.thingiverse.com/thing:5430772
I added rounded edges where possible to reach smooth touch when removing stuff from insert.

All modifications do Declon's model are described in section "Differences of the remix compared to the original"

Insert still fits “Hero's Treasures” and small extension “Adventurer's Toolkit” - the one with companions and balista. Meeples fits with applied stickers.

__________________________________________________________________________
Do you own also New Adventures extension? Check also my add on to this remix:

__________________________________________________________________________
To use all features, you will need magnets:
8pcs D6x1 mm

  • 4pcs for accessories_lid

  • 4pcs for tiles_n_tokens_lid

28pcs of D6x3 mm

  • 4pcs for top and 4pcs for bottom side of coloring_book_tray

  • 4pcs for top and 4pcs for bottom side of accessorits_tray

  • 6pcs for top side of tiles_dices_hearts

  • 2pcs for top and 4pcs for bottom side of tokens_tray

tip: you do not need to buy both types of magnets, D6x3 can be replaced with 3x D6x1. Through you would need too many of D6x1 for this insert.

Glue the magnets with any superglue.
Recommended to insert magnet with tool, i.e. this one:

__________________________________________________________________________

Printer: MK2.5S
Noozle: 0.4mm
Material: PLA for inserts / PCTG (transparent) for lids
Support: not needed
Brim: not needed

Note: Printing with transparent materials is quite specific and slow. If you want to make your life easier, use PLA instead of PCTG.

Enjoy and happy printing :-)

Tagi