1 / 6
UPDATED Arduino Nano Bumper with added protection (for screw terminal "shield") — zdjęcie 1
1 / 6

UPDATED Arduino Nano Bumper with added protection (for screw terminal "shield")

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A simple "bumper" frame with added protection for an Arduino Nano adapter with screw terminals.

Ocena
0 / 5
Polubienia
6
Pobrania
34
Wydruki
0
Wyświetlenia
301
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

A simple "bumper" frame for a small Arduino Nano adapter “shield” with screw terminals. This version adds walls around all sides of the PCB, so that components that are mounted onto the screw terminals are somewhat protected while handling the thing. 

Note: The first version had these walls only on two sides, which made them somewhat fragile. The updated version (v2) now has walls all around. v2 is the recommended version.

My application is an Arduino Nano that is set up as ISP. The three LED (for Hartbeat, Communication and Error) are visible in the photo.

Printed using PLA, 0.2 mm layer height. 

 If you don't need the sidewalls, there is also a version that consists only of the basic frame. 

Note that this is not for the “official” Arduino Nano Screw Terminal Adapter. The bumper shown here is for the smaller, simpler adapter that is visible in the photo.

Tagi