Outdoors Bait Holder For Ants (Fully Customizable)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An outdoors bait holder for ants with options for lids
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 54
- Wydruki
- 1
- Wyświetlenia
- 249
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution
This is an outdoors bait holder for ants that I designed in Fusion360, it's fully parametric and it comes with 2 types of lids that you can choose. A flat one and a dome one.
- The flat one is cheaper and much easier to print but it might not be that effective at repelling water.
- The dome one is harder to print and uses a bit more material but will repel rain easily.
Don't print this in PLA if you're planning to use this outside, it won't last long. I printed them in ABS and they should be pretty waterproof.
How to use:
1. Bury the pin fully into the ground so that the ants can climb on the wall of the bucket.
2. Fill it up with bait with the dose specified in the bait's label and finally.
3. Put the lid on.
I haven't done extensive testing on how long they should last but they're relatively cheap to print if they break down.