LazBoy Wand - Rocker and Button Cover Replacement
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A replacement rocker switch for a 2013 LazBoy Luxury-Lift recliner wand and a cover for the button holes in the wand.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 63
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Older LazBoy replacement wands, if they can be found, are very expensive, especially when only the rocker is broken. I found a model on Printables but needed to modify it to work with the 2013 wand for a Luxury-Lift chair.
Also the chair does not have heating or massage features and those button holes were originally covered - long since gone, so I modeled a new covering which can be installed with double stick tape using these holes for alignment of the cover. After placement of the tape, cut out the tape and then place the cover on.
Rocker printed with MK3s using Prusament Marble Gray PLA and 60% infill, with supports only under the two wings and the areas where the pin is placed and then only at the edges. The final cover was printed using a Polaroid Black PLA (shown in Marble Gray PLA, Polaroid Black PLA is not shown ).