Woodturning - SuperNova Chuck Jaws
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Base for designing your own chuck jaws to fit the Teknatool SuperNova Chucks
- Ocena
- 4 / 5
- Polubienia
- 11
- Pobrania
- 100
- Wydruki
- 0
- Wyświetlenia
- 460
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Use this at your own risk and caution!
I needed some specialty jaws for holding a finished workpiece without damaging the surface. For this, I designed these special jaws to an exact fit.
These jaws fit on the Teknatool SuperNova Series (Nova2 and ProTek confirmed to fit).
The main thing here is the “baseplate” for you to add your own holding jaws as needed. Also added are the 70mm dovetail jaws I used and some pen blank holders.
Please print this in the orientation shown in the .3mf files - the mating surfaces (towards the chuck) should be pointing up. Otherwise you will not get the neccessary fit. Supports are required.
And of course use lots of perimeters and infill!