Ikea Linnmon table tools
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
various things to 'upgrade' the Linnmon table series from Ikea
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 816
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
I wanted to have an angled table for my music equipment, so I've created these leg adapters.
They are straight forward to print, number of walls is recommended to set to at least 5 better more for heavy load, infill can be rather low, main stability is provided by walls. Support is needed, I was going to build a support free model but never finished it. These leg adapters are created for the 60 cm depth table sheets. Pay attention to the rotational alignment of the adapters otherwise you'll end up like shown in the picture ;)
The various hooks for the cable and socket management can be printed with about 3-4 walls, I recommend PETG since PLA tends to bend over the time. The hooks are not very tight since I've learned that the table sheets vary in thickness a little bit. If too lose I have used pieces of adhesive tape to get a good hold.