1 / 5
Gridfinity bin for Waveshare 1.69in Touch LCD Module
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Gridfinity 1x1x3 with magnets for Waveshare 27057
- Ocena
- 5 / 5
- Polubienia
- 4
- Pobrania
- 67
- Wydruki
- 1
- Wyświetlenia
- 437
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
About
Gridfinity bin for Waveshare 1.69in Touch LCD Module.
You will need at least 2x M2x12 screws to screw it into place.
Used Bin - 1x1x3 - pmcquay.stl as a base model.
Part of my smart enclosure for 3D printer.
Please give a like and post makes and provide comments for further improvements.
Changelog
- 2025.01.05 initial release
Dimensions:
- width: 42mm (gridfinity)
- depth: 42mm (gridfinity)
- height 22mm (3u gridfinity)
- magnets 6x2mm, optional
- I suggest 0.2mm layer height
- infill whatever you like but 20% is recommended
- supports are recommended
- no brim
- move the seam to the back of the print
- for nice finish of the top print it upside down, be careful when removing supports, though.
Assembly
- print it
- use 2mm drill to clean up the holes
- check if the display gets into the printed part properly without any obstructions, use a toothpick to push it from the bottom to disassemble the display and the printed base
- write down cable pinout on the back of the display (take a photo)
- push the cable through the hole, connect the cable to the display
- screw in two M2x12 screws to the plastic part so they stand out a bit
- put the display into the printed box, make sure cables are not tangled around the screws
- screw in the screws softly
- check if the display works
- optionally glue in magnets to the bottom of the box