OddityRC Toothpick dual battery holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds two 750mah 2s li-po batteries connected in series to get 4s voltage.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 91
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Designed to mount two 2s batteries under the OddityRC toothpick drone frame.
Compatability: It has only been tested on the 5-inch version; however, it should fit the 4-inch version as well. Check dimensions for compatability with other frames.
Dimensions:
- 20x20mm mounting
- Holes for M2 screws
Hardware:
- 4x M2x12 screws
- 4x M2 nuts
Support my work: All of my models are available for free. If you'd like to show your appreciation, consider Buying Me A Coffee.
Filament / Print instructions : TPU - 100% infill, Print with Tree supports at an angle as shown in this picture:
Change Log:
Rev 01: Slightly thicker walls for more durability, flat surface on the side to glue an LED light onto.