Hollyland Lark M2 Combo Case with latching top
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Are you annoyed the charging case only holds the camera receiver and not the mobile receivers? No longer.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 188
- Wydruki
- 0
- Wyświetlenia
- 856
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I have a Hollyland Lark M2 Combo wireless mic and was annoyed that the mobile receivers would constantly get lost in the carrying bag since they are so small. So I set out to find one to print. I found the model by Alko, but the tolerances were quite loose with no top so they fell out if the case was tipped over. The walls were also thick, so it took up a lot more space in the carry bag.
I took their general design shape and improved upon it for my needs, making the walls thinner and the tolerances a little tighter so they fit a bit more snug. I also added a latching top so that I could throw them in the carry bag without worrying about them falling out. I left the cutout for pulling the case out, as well as the charging lights and an opening so you can charge the case via USB-C without taking it out.
This was my first complex model, so it is a bit rough around the edges. If there are certain parameters you'd like adjusted, let me know and perhaps I can make those changes for you.
I printed these oriented as pictured in the second photo with PLA. I used minimal grid supports for the charging light and USB-C cutouts just to be safe, but they are not needed for the overhang on the base. It's possible that you may not need supports at all, as the bridge is fairly short.