Voron V2 Bowden Umbilical Mount

Ended up with this when I moved to sensor-less homing removing the cable chains.

• This is not designed to fit stock rear panel.
• It will forfeit at least 20mm of Z height.
• It may rub wires long term
• No supports
• Built in counter bore bridging
• STL's should be rotated to match included print bed image. 

The bearings are result of over engineering for cool factor, but I had them and the double t post on hand. It hardly moves, but this is sort of a positive.

The PC4-M10 threads are just guides printed in this orientation, you may need to be forceful or use a tap. If threading with a tap; assemble and tap while not attached to the printer. 

I printed in PP-GF30. 0.5mm nozzle and 0.25mm layer height.

BOM:

• 1x Double T post, m3 threaded both sides
• 2x F695 2rs bearings
• 3x M3 Roll in nuts (or T nuts) 
• 4x M3*12 BHSC
• 2x M3*16
• 1x M3*25
• 2x M3x4x5 heatsets
• 2x M5-1mm thick washers
• 1x PC4xM10 Pneumatic Connector like these, the one you took out should work
• 3x 4"x0.1" small or smaller zip ties  (ideally Tefzel/ETFE for longevity) I used these
• ½" Wire loom

Toolhead Side:

  I used this with stealthburner until i replaced stealthburner.