1 / 18
Stay Put - Clip-on Surfaces and Bins for 3cm Wire Shelves — zdjęcie 1
1 / 18

Stay Put - Clip-on Surfaces and Bins for 3cm Wire Shelves

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Plates and bins that clip onto wire shelving, when the bars are each 3cm apart.

Ocena
0 / 5
Polubienia
13
Pobrania
18
Wydruki
0
Wyświetlenia
112
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Share Alike

Intro 

Do you have a set of wire shelves, which are difficult to use for things that aren't super wide and flat?  We have a set in our pantry, and bottles and other small-footed items are a problem.

If you find that the “wires” on your shelving are all 3cm apart, like mine, you can print off some of these plates and bins to make an even surface for these things.

You'll find that there's a grid system on the bottom of each part, so that you can choose the orientation.  Each part also has little teeth near at all four corners, so that you can snap them in place.  All are easy to print; there's no angle over 45 degrees, except technically some fillet corners, and the only bridging is on the undersides, where it can't be seen.

File Descriptions

I've made a couple of variants.  Each one is named XxY, in terms of how many 3cm squares makes up their footprint.  I'm listing them here in order of my favorites:

D - Flat Solid Surface, hollowed underside

This one is meant to be printed upside down.  It gives a nice, solid finish, and the middle of the bottom is cut out, as a means to save filament.  If printed right-side up, the larger ones would be a bother for bridging

E - Flat Perforated Surface

D, except with a fully-formed bottom side, and rounded-square holes cut out, to save some filament, and completely remove bridging, if that's an issue.

C - Bin with Sloped Sides

The first number listed after the XxY is how many mm the front lip rises above the inside bed.  The second number is how many mm above that until the back lip.

A - Bin with Solid Bottom

The number after XxY is the parallel vertical distance (mm) from the inside bed to the top of the bin lip.

B - Perforated Surface with 5mm lip

Like E, with a constant 5mm lip.

Tagi