1 / 5
Mount for Superelliptic Fang Duct for Voxelab Aquila — zdjęcie 1
1 / 5

Mount for Superelliptic Fang Duct for Voxelab Aquila

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Aquila mount for https://www.thingiverse.com/thing:4345038

Ocena
5 / 5
Polubienia
10
Pobrania
37
Wydruki
1
Wyświetlenia
704
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution

This is a mounting plate for Ekeberg's “Superelliptic modular cooling fang” which can be found here: 

https://www.thingiverse.com/thing:4345038/

I used the “superfang-fang-4010.stl” file from there. Any of the fang ducts from there should work. Other similar fang ducts may mount too but some may impact the X-axis carriage.

The plate itself is a modification of Knubbelix's remix mounting plate with cable strain relief which is found here:

https://www.thingiverse.com/thing:4691328

The plate press fits onto the X-axis carriage and is mainly held down by the hotend heatsink after it is screwed down. Depending on your printer, the plate's holes may fit too tightly over the carriage. I had to widen the holes very slightly with a 7/32" drill bit. There is also a single screw hole to attach to the carriage that I ended up not using.

It uses M3 bolts and nuts to hold everything together. I used a modified version of the original heatsink fan duct that has a counterbored hole so I can use a M3x12mm bolt to attach the duct.

I also included a version of this BL Touch mount from n9jcv (https://www.thingiverse.com/thing:4765401) that has been shrunk slightly to not interfere with the mounting plate.