Mount for Superelliptic Fang Duct for Voxelab Aquila
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Aquila mount for https://www.thingiverse.com/thing:4345038
- Rating
- 5 / 5
- Likes
- 10
- Downloads
- 37
- Makes
- 1
- Views
- 706
- Reviews
- 1
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution
This is a mounting plate for Ekeberg's “Superelliptic modular cooling fang” which can be found here:
https://www.thingiverse.com/thing:4345038/
I used the “superfang-fang-4010.stl” file from there. Any of the fang ducts from there should work. Other similar fang ducts may mount too but some may impact the X-axis carriage.
The plate itself is a modification of Knubbelix's remix mounting plate with cable strain relief which is found here:
https://www.thingiverse.com/thing:4691328
The plate press fits onto the X-axis carriage and is mainly held down by the hotend heatsink after it is screwed down. Depending on your printer, the plate's holes may fit too tightly over the carriage. I had to widen the holes very slightly with a 7/32" drill bit. There is also a single screw hole to attach to the carriage that I ended up not using.
It uses M3 bolts and nuts to hold everything together. I used a modified version of the original heatsink fan duct that has a counterbored hole so I can use a M3x12mm bolt to attach the duct.
I also included a version of this BL Touch mount from n9jcv (https://www.thingiverse.com/thing:4765401) that has been shrunk slightly to not interfere with the mounting plate.