1 / 1
Calamity Toolhead Strain Relief Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My current wire strain relief solution for the Calamity Toolhead.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 7
- Wydruki
- 0
- Wyświetlenia
- 132
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
I don't use toolhead boards. This is how I relieve wire strain on the Calamity toolhead designed by lukeslabonline.com.
I printed in PP-GF30. 0.5mm Nozzle, 0.25mm layers. 5 walls, 6 top/bottom 40% gyroid. PP needs the extra walls.
The back mounting screws are a tight squeeze requiring careful use of ball end hex keys. I doubt this will be the last version, but until it breaks it's rocking out as is.
Should accommodate ~½" to 5/8" umbilicals.
BOM:
- 4x M3x6mm BHCS - base plate mounting, no room for washers :(
- 2x M3x10mm BHCS - top of halo attachment, can be longer
- 2x M3 washer - metal on plastic, use washers if when you can
- 2x M3x4x5 heat sets
- 2x 4"x0.1" or smaller zip ties. I use these for temperature resistance