1 / 1
Calamity Toolhead Strain Relief Mount
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
My current wire strain relief solution for the Calamity Toolhead.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 7
- Makes
- 0
- Views
- 132
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Other Printer Parts & Upgrades
- License
- Creative Commons — Attribution — Share Alike
I don't use toolhead boards. This is how I relieve wire strain on the Calamity toolhead designed by lukeslabonline.com.
I printed in PP-GF30. 0.5mm Nozzle, 0.25mm layers. 5 walls, 6 top/bottom 40% gyroid. PP needs the extra walls.
The back mounting screws are a tight squeeze requiring careful use of ball end hex keys. I doubt this will be the last version, but until it breaks it's rocking out as is.
Should accommodate ~½" to 5/8" umbilicals.
BOM:
- 4x M3x6mm BHCS - base plate mounting, no room for washers :(
- 2x M3x10mm BHCS - top of halo attachment, can be longer
- 2x M3 washer - metal on plastic, use washers if when you can
- 2x M3x4x5 heat sets
- 2x 4"x0.1" or smaller zip ties. I use these for temperature resistance