1 / 2
PolyDryer Wall Control/Pegboard Compatible Mount
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Couldn't find any Wall Control compatible mounts for the PolyMaker PolyDryer so I remixed the original wall mount with three major changes:
- Adapted the screw holes to 1" spacing on the center to support standard pegboard hole pattern, anchored with the bottom most screw hole
- Increased the screw hole diameter and countersink depth to match M5 flat head countersunk bolts
- Doubled the number of screw holes for maximum holding powah!
You will need access to the rear of your Wall Control/pegboard to install this. I was unable to figure out a way to use Wall Control native hooks for this remix.
Non-affiliate, direct, link to Amazon nuts and bolts I used in the pictures - https://www.amazon.com/gp/product/B073SVMX3T
This is my first remix and posting on Printables, any feedback would be appreciated and welcome! Thanks for checking it out and I hope it's helpful!