Xshot Ragefire - Dual Stage Cage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D printed 2-stage motor cage for the Ragefire belt-fed blaster.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 65
- Wydruki
- 1
- Wyświetlenia
- 760
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Toys
- Licencja
- Creative Commons — Attribution
Remix of BuffdaddyNerf's X-Shot Ragefire flywheel cages, added a second stage for increased performance.
Hitting around 200-210fps with Kraken 3s motors into Loki 3s motors, all with Kepler flywheels on a 3s lipo. Hits around 130-150fps with same motor setup on a 2s lipo.
Cage is 40mm spacing for both the first and second stage, nothing fancy there. Uses the original four motor screws and silicon pads the stock cages uses.
Requires six cuts inside of the ragefire shell. Five on the side that the cage mounts to, and one on the other side (pictures below for reference) to make space for the second stage cage and wheels. Even with these cuts, the shell still screws together securely. I used the cheap blue clippers that came with my 3d printer. They don't have to be pretty, only short enough the cage, motors, and flywheels don't touch them.
I also had to remove the white plastic gear and shaft that rotates the stock ragefire barrel to because it occupies the same space the second stage of the cage sits, so no barrel attachment with this cage :(.
Cuts to the same shell side that the motor cage is mounted:
4 of the cuts are post trimmings to make room the the second stage motors and flywheels, and one cut to the orange square so it doesn't tilt the cage.
Before: (cut the areas with the red circle)
After:
Cuts to the other shell side: only one cut to a post that would otherwise touch the flywheels
Before:
After: