Charger enclosure for TP4056 and AAA sized Li-Ion Batteries (10440)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Enclosure designed for two TP4056 and AAA battery holders to charge two 10440 batteries in parallel.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 37
- Wydruki
- 0
- Wyświetlenia
- 259
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Protective enclosure designed to fit two TP4056 modules and two AAA sized battery holders to charge two 10440 batteries in parallel.
This enclosure is designed to attach together using the snap fit joints. Printing orientation is unfortunately against the optimal strength of the snap fit to ensure the LED opening can be printed as clean as possible.
Support is required for the enclosure body, it should just be a small tree support for the overhang designed to slot and keep the battery holders in place. Designed holes at the bottom of the enclosure for easy removal of those supports.
Recommended Print Settings:
- Layer Height: 0.15mm
- Wall Count: 3
- Infill: 15%
- Wall Ordering: Outside to inside
- Supports: Tree support on the body only
- Build Plate Adhesion: Skirt
If you try this out, feel free to comment how it went!
I've made a video to show the process of making this charger as well if you're interested: