1 / 5
WLED Anjuna logo v3
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Sculptures
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Components used
- Adafruit QT Py ESP32 Pico
- Adafruit MiniBoost 5V @ 1A - TPS61023
- 1 metre of WS2812B tape (10mm wide, 60 LEDs/m)
I added a 7x7x6mm heatsink to the ESP32 Pico IC (using thermal glue) as it was running rather warm & I was concerned about long term reliability. Turns out WLED sets the WiFi transmit power to the maximum (20dBm) by default & lowering this reduces the temperature of the chip greatly.
I have included a ‘generic’ version of the electronics lid without the hole for the heatsink, which should work with any QT Py/Xiao board.
The WLED Project can be found here.