LA1010 Case

I use the LA1010 logic analyzer for my circuits often.  The only problem is the case is a little bulky and I wanted to slim the form factor down as much as possible.  I have a breadboard frame that I mount the analyzer onto for consolidated prototype setup.  This case is the smallest form factor I could create.  I used semitransparent PETG for the top so I can see the indicator light on the analyzer board.  The production case has a hole over the led.  Although the indicator is not super critical since the software works well to give you a status.

You will also need 4 x 2.5 x 14 mm hex screws and 4 x M2.5 x 4 x 4 threaded brass heat inserts.