Barnett Crossbow Replacement Quiver Attachment
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
My neighbor asked if I could design and print a replacement attachment for his Barnett Crossbow quiver. He said he,…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 69
- Wydruki
- 0
- Wyświetlenia
- 596
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
My neighbor asked if I could design and print a replacement attachment for his Barnett Crossbow quiver. He said he, his wife and brother all had the same model and the quiver attachment broke on all three and the manufacturer would not respond when contacted about a replacement.
My design is a beefier block with out the material saver hollowed out areas, a steel washer inserted during printing and a clip to help ensure it doesn't become detached.
He used it hunting last weekend and said it worked great.
It might print better if you did use support for the tunnel area that slides over the rail on the underside of the crossbow barrel/rail so to speak.
I just filed it down a tad. No one sees it when it's installed anyway.
Print Settings
Printer:
Bibo
Rafts:
No
No
Resolution:
150
33%
Filament: Inland PLA
Notes:
Insert washer at about 54%. I designed in markers on the front so you can see about when the washer pocket starts and is about to finish printing.
The washer is 22mm OD and 5 mm ID, Your basic fender wahser. (A little over 1mm thick.)Post-Printing
Trim as necessary.
How I Designed This
TinkerCAD
Category: Other