CoPrint ChromaHead Vortex/Toroidal/360 Cooling Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Circular Ring Cooling setup. Designed to fit both the Stock and Ceramic Ring Hotend. Uses stock fan.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 72
- Wydruki
- 0
- Wyświetlenia
- 494
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Circular Ring Cooling setup.
Designed to fit both the Stock and Ceramic Ring Hotend. Centered around the nozzle tip. Uses stock fan.
Screws: 1x Short M3 screw (8-10mm up to 20mm) 3x M3x20mm 1x M3x25mm
Installation:
Installed by mounting on the heatsink. One M3x20 goes in the top front hole of the heatsink cooling fan. Short(er) M3 screw goes into the heatsink front bottom screw hole. M3x25 screw goes in blower fan hole above heatsink. M3x20 screws secure fan to mount. (Optional) M3 grub screw for heatsink back bottom screw hole for additional stability. Capped screw will not fit; no head space)
Fan fitment is very snug. It should snap in neatly wit a bit of pressure.
Highly recommended to have skew correction calibrated for your printer otherwise some tolerances may not come out correctly.
Tree Supports only needed to base the ring and support the top mounting arm. All holes can be support blockaded to reduce material waste.
Print out of PETG or ABS for temp resistance. Designed to be printed at 0.2 Layer Height.
Category: 3D Printer Parts