X10 HR12A PalmPad Remote Control Wall Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Wall mount for HR12A Palmpad
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 28
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution
TL;DR - Print V4 in PETG
This design is intended to allow you to mount your X10 HR12A PalmPad Remote to your wall in case you like to have it by your light switch or otherwise. I'm including the 3D scan I did of the remote as well. I made a few versions:
V1 - No retention tabs. Remote has a little slop when inserted in bracket. Countersink holes were not quite as deep as I wanted them. I increased the countersink depth on the other revisions.
V2 - Exposed retention tabs. The retention tabs can be seen from the side. Gives slight resistance and removes slop in bracket. The retention is light enough that remote can fall out when turned upside-down.
V3 - Hidden retention tabs. Similar design as v2, just made tabs thinner and added facade to hide retention tabs on side view. Retention is much stiffer.
V4 - Updated V3 to reduce interference on retention tabs - this feels like the sweet spot. I also created a version where the countersink is a #6 profile. All the others have a #8 CSK profile.
I printed in PETG for toughness, durability, and flexibility.
I'm putting both stl and step files here for ease of modification.