Ikea LACK Tool Table - Fillet Remix
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A remix of Horacio's "Ikea LACK Tool Table" that better fits the contours of Ikea LACK tables.
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 39
- Wydruki
- 1
- Wyświetlenia
- 158
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
When I printed one of the wheel brackets of Horacio's “Ikea LACK Tool Table” as a test, I noticed that the inside corner of the bracket had a chamfer that did not properly fit the table. Because of this, there will always be a little space between the table leg and the bracket at at least one side (you can see this if you check the pictures of the makes of the original model).
This remix replaces these chamfers with 2.00mm radius fillets, which better fit the horizontal corners of the table surface and the vertical corners of the legs.
Note: the wheel bracket shown in the pictures actually has a 2.50mm fillet. I have since corrected this. The models that are available here all have a 2.00mm fillet where applicable.