Phone Holder/Cover for P1S/P1P Controls
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This adds a cradle over the stock controls on the P1P and P1S that can be flipped up if needed and allows for power
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 193
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bambu Lab Parts & Upgrades
- Licencja
- Creative Commons — Attribution
This is a remix I made based off the TeachingTech xTouch enclosure mod to go over the P1S/P1P control screen. I didn't want to use the xTouch in the original, but I had an old Pixel 3a that I now have sitting in the cradle. Fits over the P1P/P1S controls, gives access to both. Right now the cradle will be bigger than the phone, as I had originally designed it with an extra case that fits the 3a perfectly to make it a snug fit. But the idea is that you can have an old phone sit in here and use a 90 degree USB connector to run a cable to the power supply inside the P1S/P1P. I actually use 2 90 degree connectors I got off Amazon to make it work without overbending the cable.
It stands upright because the Bambu Handy app does not go horizontal yet. I may remix it in the future if/when they finally allow for that.
It will fit phones that are up to 13 mm thick and 74.8 mm wide (these are the measurements of the interior space, so if it measures exactly this, it will be tight, otherwise will have more wiggle room.)
You will need 2 x M3x12mm bolts for attaching the two pieces and a USB-A to whatever end your device is using cable that is roughly 20 cm long.