Festool CXS Internal Bit holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Holds 8 extra bits inside the vestigial space in front of the grip on a CXS driver. Bores for magnets.
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 64
- Wydruki
- 1
- Wyświetlenia
- 396
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
The original CXS has a vestigial space behind the built-in bit storage, which only could hold 4 bits. I have way too many fasteners around my house and shop, and figured I could design something that securely holds an extra 8 bits in this space by simply removing the battery.
I printed it flat side down (opposite to how the STL will load), so it prints at a ~15d angle.
I designed with 5.2mm holes for a 5mm magnet, and superglued them in. The bits won't get lost inside the drill without magnets, but does keep the bits in place while you're handling the holder outside the drill, as well as cut down on extra noise from bits moving while you're using the drill.
Note that this is for the original CXS, not new CXS12 or CXS18. I'm also guessing that this space was originally used with a different battery, so make sure to check yours!
This is an important part of my workshop! If you have ideas on how to improve, please let me know!