BG68 - Tester68 Thick-Bezel Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tester68 keyboard drop-in case
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 9
- Wydruki
- 0
- Wyświetlenia
- 124
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I call this the BG68 ( Budget68 )
This is a drop-in case for the Tester68 keyboard.
This is a case design inspired by the OG60 from KBDfans. Hence the name BG68.
It doesn't use any mounting method since the PCB, foam and plate are dropped into the case.
To complete this build you need a way to power the pcb with batteries.
I used this ( JST connector was not compatible with the board, had to DIY ) :
and attached it to the bottom hole of the case using some Velcro ( so that you are able to remove it and change the batteries when needed )
I'm sure someone could make this hard mounted etc. but i am not bothered enough :D
The print was ordered from Craftcloud so no 2 part case was designed.
This case should fit similar size 68 key keyboards, but check the dimensions before printing.