1 / 3
Pastamatic V-Slot or T-Slot Mount — zdjęcie 1
1 / 3

Pastamatic V-Slot or T-Slot Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Modification to two parts of Pastamatic and additional handles for the ends of V-Slot or T-Slot mounting frame.

Ocena
5 / 5
Polubienia
20
Pobrania
135
Wydruki
1
Wyświetlenia
1387
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I changed the gap between the Target & passive Cradle from 0.3mm to 0.05mm gap.  That was a nice fit for me.  I added a test print for 0.05mm gap & 0.10mm gap as Cradle_Mod_05_Test.stl & Cradle_Mod_10_Test.stl.  You will need to have printed the driven cradle part from original parts to test fit this.

There is also a Pastamatic_Mod.3mf with the print settings used by the original design.  You will need the rest of the files from the original design located here. https://www.printables.com/model/466883-pastamatic-filament-spool-winder-for-bambu-lab-x1c

The end handles I modified the Handle - Side.stl from: https://www.printables.com/model/479022-stand-for-bambu-lab-filament-spool-switcher-winder

I used the drive spindle clip.stl & spindle clip.stl to hold spindles on from: https://www.printables.com/model/1058220-easy-hand-crank-for-pastamatic

I used 2 - 2020x500mm length of V-Slot Linear Rails using Handle_End_V_Slot.stl for the end handles.  I also included a version for T-Slot if you prefer.  You might be able to go a little shorter than 500mm on the aluminum extrusions, but not much.

I included the fusion 360 source files if you wish to edit these further.

The additional hardware I used was:
 4 - M5x25mm (to connect Crossbars to the V-Slot)
10 - M5x12mm screws
14 - T-Nuts
 2 - V-Slot 2020x500mm length Linear Rails

Tagi