Folding Ruler Dispenser - Wall mount, T-slot, french cleat and Ikea Skadis compatible
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a folding ruler dispenser that will mount to regular walls, Festool MFT-3 T-slot, french cleat and IKEA Skadis.
- Ocena
- 0 / 5
- Polubienia
- 32
- Pobrania
- 197
- Wydruki
- 0
- Wyświetlenia
- 576
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a folding ruler holder/dispenser with flexible mounting options. It will hold approximately 5 2m length rulers. Let me know if there is an interest for a different sizes.
Mounting options
The following mounting alternatives are possible:
- Wall mount using regular 4-5mm countersunk wood screws.
- IKEA Skadis using this Skadis adapter and M4 screws: https://www.printables.com/model/1129418-skadis-adapter-for-festool-printable-holders
- French Cleat using the attached adapter and M4 machine screws.
- Festool MFT-3 or any other T-slot system using the attached adapters
The Skadis adapter, french cleat adapter and T-slot adapter will need a M4 machine screw for direct threading with the screw. Preferably with 10mm length.
Releases
| 2025.01.18 | v1.8 | Initial Release |
Printing notes
Test prints done using add:north HT-PLA with good result. The mounting holes and adapter slot does not need supports, but the lower part on the front will need supports as shown below:

The adapters should be printed in a strong material that will withstand direct threading with a machine screw. If the material is very brittle the adapter might break. I have tested with many standard PLA filaments with good results, but it is mentioned just so that you are aware.
General notes
The adapter for T-nut/Festool MFT-3 is remixed from the MFT-nut provided by Festool during the Printables Festool competition. Thanks to Festool for allowing remixing.