1 / 9
Sovol sv07 klipper screen side holder with 3 variants — zdjęcie 1
1 / 9

Sovol sv07 klipper screen side holder with 3 variants

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I couldn't find a klipper screen holder for the sovol sv07 (not sv07+), so i made one of my own

Ocena
0 / 5
Polubienia
2
Pobrania
23
Wydruki
0
Wyświetlenia
181
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

I had to place my sovol sv07 inconveniently and all the sideways klipper screen holders were for the sv07+ (not compatible), so I made it myself.

Use cases:

  • 30 degree stand with rib: a robust and ergonomic stand
  • 30 degree stand: a lightweight and ergonomic stand. may flex a bit
  • 15 degree stand: a low angle stand. Best if the printer is placed higher than chest level

!!DISCLAMER!! 

  1. Although the 30 degree stands do not go over the build plate, the screen does. This could cause collisions with prints that max out the X axis.
  2. Unfortunately, the ideal printing orientation requires a lot of supports, but it aligns the layer lings such that.
  3. In case it was not clear, these models are NOT COMPATABLE with the sovol sv07 plus

Tagi