Creality Light Bar Mount - E3NG V1.2
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reuses the stock Creality light bar to light up the bed of the NG V1.2
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 536
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mounts for the Creality light bar to be used on the ENG v1.2.
Utilizes the mounting holes on the back of the XY gantry that are usually used for the enclosure. Designed to work with the optional bracing. The cable for the light can be routed down the left hand mount and through the hole on the top right of the back panel.
NOTE: Make sure that your bowden tube does not collide with the light bar! The light bar slightly hangs over the print area in this version.
Hardware and mounting
- 2x M3 heat inserts (if you hadn't previously installed them for the enclosure)
- 2x M3x10 or M3x12 SHCS
- 2x M5x12 SHCS (may be able to use slightly longer or shorter)
Printing
Parts are already orientated for printing. It's recommended to use a brim or mouse ear and supports. 15% infill of your choice and 0.2mm layer height.