Jeep Tube Door Latch
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Needed an inexpensive way to make a latch for a set of tube doors I made for a Jeep Wrangler (TJ). Similar uses would…
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 23
- Wydruki
- 0
- Wyświetlenia
- 496
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Needed an inexpensive way to make a latch for a set of tube doors I made for a Jeep Wrangler (TJ). Similar uses would work too, like for a gate or something you have access to press the button. I designed these to be able to push to close without needing to push the button. You will need a small spring for the mechanism on the inside. I got mine out of the set you can get at Harbor Freight. A couple 4-40 screws or near equivalent metric screws are required and I believe a 1/4-20 screw for the center pivot. Holes are small so you can drill and tap. Obviously do not depend on these latches keeping the doors closed in a roll over or similar event off roading. Always wear a seat belt. I included the mount but I didn't like it and just welded a plate with matching holes. If you are fabricating similar tube doors I'm sure you can figure out a better mounting method.
Print Settings
Printer:
Malyan M150
Rafts:
No
No
Resolution:
.2
Notes:
Print with ABS & the more infill the better.
Category: Automotive