1 / 3
4000D/X 2.5" SSD tray to 120mm fan adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Fits 120mm fans above the PSU where SSD trays could go
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 85
- Wydruki
- 0
- Wyświetlenia
- 524
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 1)Remiksy (0)Kolekcje (13)Powiązane
The only additional hardware needed are the screws to attach the fan, and a screw to secure it to the PSU shroud.
Support is recommended for the two hooks, and for the other hole on the bottom (top when turned right way after printing) only if your tolerances are good.
Any material is fine.
Does not block any cable routing below motherboard tray and leaves room for any headers in that location, because of this you need to screw the adapter down through the blades of the fan, after of course getting the fan on the adapter first.
