Transducer mount for aluminum boat
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Transducer mount that allows drilling through protruding hull material instead of the transom.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 365
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution
This bracket allows mounting a transducer to the back of your boat without drilling through the transom (potential water intrusion). Most aluminum boats have hull material protruding past the transom, which this bracket is mounted to. This was made for a 10 degree deadrise angle, but would likely work on other angles, as the transducer mounting bracket typically has some adjustment to it. I used #10 hardware (10-24), and the fit for holding the nylock nuts was just right. This was for a Garmin chartplotter / fish finder. Printed in ASA for outdoor exposure. Nothing special for printer settings. I believe I used 3 perimeters and 20% grid infill. Other setting will likely work fine.
Please post your make or any questions or comments! Thank you.