Multiboard straight peg, 5,6 x 25mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a very straight peg for mounting light tools that have narrow mounting holes to Multiboard
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 46
- Wydruki
- 0
- Wyświetlenia
- 114
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a more narrow Multiboard peg for mounting tools that are light, but have quite narrow built-in mounting holes (for nails or similar).
All variants:
- 5,6 x 15mm straight peg
- 5,6 x 25mm straight peg
- 5,6 x 35mm straight peg
The peg radius is 5.6mm, and length is roughly 25mm. It has also small chamfer for strengthening the peg (although I have not tested the pull strength) and small notch in the end for preventing tools from sliding off.
Printing settings:
I used PLA for printing, 15% grid infill, 3 perimeters for strength. Printing orientation is side against bed, no supports needed.
Model uses Multiboard Pegboard Click as base.