1 / 4
Radiator booster fan / Heizungslüfter 120mm — zdjęcie 1
1 / 4

Radiator booster fan / Heizungslüfter 120mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A fan to boost your heaters output. Ein Lüfter um die Leistung der Radiatoren zu erhöhen.

Ocena
1 / 5
Polubienia
16
Pobrania
99
Wydruki
0
Wyświetlenia
1117
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

!!!Deutsche Version hier drunter!!!


I’ve designed radiator fans myself. The fan mounts are equipped with rails on the sides to keep the fans together and prevent them from sliding around on the floor.

The whole system is powered by an old 12V laptop power supply I had lying around. I simply cut off the plug and connected the wires using WAGO 222-5 clamps (the thin wires were no issue). If you know how to solder, you could probably make it look a lot cleaner …

The wires run from a large junction box into a smaller box, where the fan wires are connected. I sealed the smaller box with hot glue – works perfectly!

BOM (Bill of Materials):

  • A 12V power supply (make sure it can handle the load! I used a 2A power supply for 5 fans).
  • A few meters of cable, e.g., bell wire from the hardware store, to connect the fans to the power box.

I’m open to ideas and suggestions, but the system works fine for me, and I don’t plan to invest much more time into it. If you’re interested, feel free to reach out, and I’ll share the files with you!


________________________________________________________________________________________________________________


Ich habe Heizungs-Lüfter selbst entworfen. Die Lüfterhalterungen sind an den Seiten mit Schienen ausgestattet, damit die Lüfter zusammenbleiben und nicht auf dem Boden herumrutschen.

Das Ganze wird von einem alten 12V-Laptop-Netzteil betrieben, das ich noch herumliegen hatte. Den Stecker habe ich einfach abgeschnitten und die Kabel mit WAGO 222-5er-Klemmen verbunden (die dünnen Drähte waren kein Problem). Wer löten kann, macht das sicher eleganter…

Die Kabel laufen von einer großen Verteilerbox in eine kleinere Box, wo die Lüfterkabel angeschlossen werden. Die kleine Box habe ich mit Heißkleber verschlossen – hält super!

BOM (Stückliste):

  • Ein 12V-Netzteil (auf die Leistung achten! Für 5 Lüfter habe ich ein 2A-Netzteil verwendet).
  • Einige Meter Kabel, z. B. Klingeldraht aus dem Baumarkt, um die Strecke von den Lüftern zur Strombox zu überbrücken.

Für Ideen und Anregungen bin ich offen – allerdings läuft das Ganze bei mir so, wie es soll, und ich habe nicht vor, noch viel Energie in das Projekt zu stecken. Wer Interesse hat, kann mich gerne anschreiben, und ich gebe die Dateien raus!

Tagi