Mobapad Joycon Grip for Nintendo Switch *Now With Status Lights*

Mobapad M6-HD / M6s joycon grip for the Nintendo Switch.

***New version added to include controller status lights***

If you use a Mobapad for your Nintendo Switch, you know the standard Nintendo Joycon Grip does not work with the Mobapad joycons (unless you take it apart and remove the grips). I used other, wider, joycon grips and was not happy with how my Mobapad M6-HD joycons felt so I designed my own. They are lightly angled to provide a more natural grip on the joycons. It is a minimalist design but gets the job done.

Two versions are offered:

• Rounded - My favorite but more difficult to print due to the rounded edges at the top of grip to mirror those of the OE Nintendo joycons. I use a brim when printing that breaks off and cleans up easily. Paint on supports only for the rounded edges (top of the grip) at the bottom of the model - check 3MF file if you're not sure.
• Square - Easier to print with 45* angles at the top edges and a flat top for better bed adherence.
• NEW Lights - Rounded version with the addition of controller status lights. This version requires clear filament, super glue, and a 1.8mm drill bit (optional to “clean” holes" 
  • Cut eight (8) pieces of clear filament approximately 8mm in length. I recommend using a razor blade to cut the ends at a 90* angle.
  • Apply small amount (1 drop or less) of super glue inside one of the top holes then push clear filament until it sits evenly between both tube openings.
    • Only do one hole at a time as the super glue can dry fast.
    • Let the super glue completely dry before using.

Each folder contains a STL, STEP, and 3MF version.

Print settings:

• Print orientation:  bottom of the “V” on the bed
• Layer height:  0.2mm
• Nozzle diameter:  0.4mm
• Wall count: 5 (top/bottom/walls)
• Infill:  25%