Door Frame Bottom (For fixing gaps caused by a change in flooring height)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Model of a standard American door frame bottom to fix gaps caused by changes in flooring height
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 84
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a model of a standard American interior door frame and trim, this can be used for fixing gaps at the bottom of door frames after replacing your flooring with a different type that is not a high as the previous (like when going from tile to laminate). I have made a bunch of sizes from 2mm to 12mm (Roughly 1/8in to 1/2in) so you can pick the size that fits your gaps best. To install just add some glue to the top of the 3d printed part and slide under the door frame and line everything up.
NOTE: After using these on a flooring job I did I found that the location of the door stop trim in the middle of the frame is different from door to door, so I have separated it in the model so you can glue it on separate to align with your doors trim (or you can choose to not even use it if you want).
PRINT SETTINGS:
You can probably print with any filament, however, since PLA tends to break down with moisture you may want to use PETG. Or you could just prime the whole PLA part before installing so it's waterproof just in case it ever gets wet then it shouldn't be a problem.
If you would like to leave a small tip for my hard work you can do so here :D https://www.paypal.com/ncp/payment/Y5DRF7PN8S5AJ