1 / 8
Milwaukee M18 T12 Soldering Station (XH-M609 MOD) — zdjęcie 1
1 / 8

Milwaukee M18 T12 Soldering Station (XH-M609 MOD)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

M18 soldering station with low voltage disconnect module added.

Ocena
0 / 5
Polubienia
5
Pobrania
29
Wydruki
1
Wyświetlenia
336
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial
  1. Mounting holes for XH-M609 are 2.8mm are intended to screw directly into the base without heatset inserts. Parts were printed with extra walls for more bite into the plastic. I used ASA-GF which helps even more. Pins for the XH-M609 board were trimmed prior to installation. 
  2. Assembly screws for the top and bottom pieces modified to use M3 all around. 3 EA M3x25mm SHCS are needed. Heat set inserts used were 2 EA M3x6x4mm and 1EA M3x4.6x3mm. Use the included STEP file to modified holes as needed for your preferred heatsets. 
  3. The iron holder uses 2EA M3 screws. One serves as a stopper and the other serves as a handle to pull the holder out for use. 

Thanks OP for the great design!