1 / 8
Milwaukee M18 T12 Soldering Station (XH-M609 MOD) — image 1
1 / 8

Milwaukee M18 T12 Soldering Station (XH-M609 MOD)

Order a print of this model

We calculate the final price from your selected file. You review and accept it before payment.

Saved on this device.

M18 soldering station with low voltage disconnect module added.

Rating
0 / 5
Likes
5
Downloads
29
Makes
1
Views
336
Reviews
0

Updated at source:

Model information

Category
Electronics
License
Creative Commons — Attribution — Noncommercial
  1. Mounting holes for XH-M609 are 2.8mm are intended to screw directly into the base without heatset inserts. Parts were printed with extra walls for more bite into the plastic. I used ASA-GF which helps even more. Pins for the XH-M609 board were trimmed prior to installation. 
  2. Assembly screws for the top and bottom pieces modified to use M3 all around. 3 EA M3x25mm SHCS are needed. Heat set inserts used were 2 EA M3x6x4mm and 1EA M3x4.6x3mm. Use the included STEP file to modified holes as needed for your preferred heatsets. 
  3. The iron holder uses 2EA M3 screws. One serves as a stopper and the other serves as a handle to pull the holder out for use. 

Thanks OP for the great design!