Microfiber Glasses Cleaning cloth Organizer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Magnetic organizer for glasses cleaning cloths to keep them off the desk
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 11
- Wydruki
- 0
- Wyświetlenia
- 228
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bedroom
- Licencja
- Creative Commons — Attribution — Noncommercial
Created in solidworks design is relatively expensive with each cloth holder requireing 2 printed parts(cheap) 2 m3 screws/nuts(6/8mm) and 2 magnets 6x2 mm 6 being diameter and 2 being thickness, same as Gridfinitys magnet size if you were wondering. This project is incomplete in many ways so i may update it with more magnet holders but feel free to make your own. Atm the non wall mount one has an Popsicle stick glued to the back of my monitor with hot glue attached tot he 3d printed part. the wall mount one should be able to hide an medium command strip horizontaly but likely can be used with smaller sizes too. Have fun yall!
Installation:
print one back and one front, glue in magnets with correct polarity to magnet holder on back of glasses cloth clamp and the holder plate, insert m3 nuts into position(i used pliers to get it in) then place cleaning cloth corner into the textured areas of the holders and tighten both m3 screws alternating sides on occasion, y voila!