Water cooling radiator mount for V-Core 3.1 enclosed
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of the 240 radiator mount to fit the V-Core 3.1 500 with enclosure
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 41
- Wydruki
- 0
- Wyświetlenia
- 302
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I decided to water cool my whole printer so I remixed the original file to fit over the trim pieces nicely & it uses 3 existing fixing screws. You do not have to work about losing the T-nuts down the profile either.
It is fairly slim & keeps the radiator over the printer & not behind it so you can still keep the back of the printer close to a wall.
I also designed it to sit approximately 10mm above the top panel (hard to see in the photo) so that you can still easily remove & replace the top panel.
This fits a radiator that takes 2no 120x120 fans on my V-Core 3.1 500x500. I do not know if it will fit others.