Multiboard clothing or garment peg with a hole, 5,6 x 20mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a peg with a hole for hanging clothes or hangers to Multiboard
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 20
- Wydruki
- 1
- Wyświetlenia
- 128
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Garage
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a variation of straight peg for hanging clothes. Built-in hooks tend to be too sharp for hanging hoodies from them, so this hook has more rounded end; it also has a hole for a hanger if you happen to need one.
The peg radius is 5.6mm, and length is roughly 20mm. Root of peg has a small chamfer for strengthening the peg (although I have not tested the pull strength).
Printing settings:
I used PLA for printing, 15% grid infill, 3 perimeters for strength. Printing orientation is side against bed, no supports needed.
Model uses Multiboard Pegboard Click as base.