Black and Decker 40V Battery Mount for Multiboard
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Multiboard compatible hanger for 40V Max B&W Batteries
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 175
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Mounts a B&D 40V Max battery to your Multiboard. The mount is 10mm deep, and the multiboard is ~6mm. I used the 20mm large shank bolts from the standard Multiboard library (not included here).
It's purposefully slightly wider to accommodate both the official B&D batteries as well as the Biswaye knockoff batteries.
Due to the cantilever construction, print from a high strength material with low deformation. I used PETG, but will likely replace at some point with ABS or ASA when/if heat becomes an issue in my garage. 1 month in and during a heat wave and no issues so far, however I'm in the high mountains so the heat wave isn't anywhere near what everyone else is experiencing.
Print on its side for strength in the cantilever portion, and use supports.
B&D 40V Max battery: https://www.amazon.com/gp/product/B01M1N3EBM
Biswaye Knockoff: https://www.amazon.com/gp/product/B07R4J9446
Multiboard: https://www.multiboard.io/ (note that this is a paid platform, but the 20mm bolts are free)
Specific (free) 20mm bolts I used: https://thangs.com/designer/Keep%20Making/3d-model/20%20mm%20Big%20Thread%2C%20Flat%20Head%2C%20Shank%20Bolt-973977