1 / 11
Sunton 7inch Display Housing (ESP32-8048S070) with Stand (FreeCAD) — zdjęcie 1
1 / 11

Sunton 7inch Display Housing (ESP32-8048S070) with Stand (FreeCAD)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A case for the Sunton 7inch ESP32-8048S070 TFT-display with a mountable stand to put it on a table.

Ocena
0 / 5
Polubienia
5
Pobrania
217
Wydruki
0
Wyświetlenia
882
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

The original design is great, but I wanted some enhancements. Because the STL showed some faults after importing into CAD, I decided to re-draw the whole model.

On the Frontframe, the mounting holes for the Sunton display got M3 thread-inserts.

Two reinforcers were built into the Backcover. If the stand is to be used, the backcover will also be equipped with two thread-inserts.

For the inserts I used Ruthex M3S (d=3,9/4,6mm l=4,0mm). The front, display and back are fastened to each other by 4x M3x8, for the stand I used 2x M3x5. There will be a little gap between front and back; its intentionally to get a little airflow - if it bothers you: I put my FreeCAD-drawing into this project, feel free to modify it.

The model was printed of Eryone PLA+ black with 0,2mm LH and a 0,4mm nozzle.

If you want more grip, you can put 2 self-adhesive pads under the stand (in the back) and 2 pads outer-left and outer-right under the frame.

Tagi