Gridfinity Olight S1R Baton II/III holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 1x1 Gridfinity holder for an Olight S1R Baton II and III. No charging port
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 92
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a 1x1 holder for an Olight S1R Baton II and III. There's a good chance it also fits the Baton I, but I don't have one of those to test.
I included the step file for easier remixing.
There are magnet holes in the bottom for standard 6mm x 2mm round magnets. It normally prints without issues and doesn't need supports, as the bridged distance is small enough. The hole is actually 2.2 deep to account for some extra space needed for the bridging passes. It's a snug fit, but at least you don't have to mess around with glue or anything like that.
Print with your standard gridfinity setup. No extra shenanigans required.
No supports required either.